Dell PowerEdge R740 iDRAC9 with Lifecycle Controller Version 3.30.30.30 RACADM - Page 109

• Configure a RAC from an XML configuration file located on a remote TFTP share. racadm set -f myfile.xml -t xml -l tftp://192.168.10.24/ • Configure a RAC from a JSON configuration file located on a remote TFTP share. racadm set -f myfile.xml -t json -l tftp://192.168.10.24/ • Configure a RAC from an XML configuration file located on a remote HTTP share. racadm set -f myfile.xml -t xml -u httpuser -p httppwd -l http://test.com/ myshare • Configure a RAC from an XML configuration file located on a remote HTTPS share. racadm set -f myfile.xml -t xml -u httpsuser -p httpspwd -l https:// test.com/myshare • Configure a RAC from a JSON configuration file located on a remote HTTPS share. racadm set -f myfile.xml -t json -u httpsuser -p httpspwd -l https:// test.com/myshare • Configure the proxy parameter. racadm set lifecyclecontroller.lcattributes.UserProxyUsername admin1 • Remove the the proxy parameter. racadm set lifecyclecontroller.lcattributes.UserProxyUsername • View the list of proxy attributes. racadm get lifecycleController.lcAttributes setled Table 83. Details of setled Description Sets the state (blinking or not blinking) of the LED on the specified module. To run this subcommand, you must have the Configure iDRAC permission. Synopsis racadm setled -l Input Example • -l - Specifies the LED state. The values are: • 0 - No Blinking • 1 - Blinking • From iDRAC stop LED from blinking. racadm setled -l 0 RAC0908: System ID LED blink off. • From iDRAC start LED to blink. racadm setled -l 1 RAC0907: System ID LED blink on. RACADM Subcommand Details 109