Dell PowerEdge R740 iDRAC9 with Lifecycle Controller Version 3.30.30.30 RACADM - Page 52

• Configure a RAC from a configuration file: racadm config -f config.txt • Configure a RAC from a configuration file and continue if a group fails to get configured: racadm set -f config.txt --continue coredump Table 15. Details of coredump Description Displays detailed information related to any recent critical issues that have occurred with iDRAC. The coredump information can be used to diagnose these critical issues. If available, the coredump information is persistent across iDRAC power cycles and remains available until either of the following conditions occur: The coredump information is deleted using the coredumpdelete subcommand. For more information about clearing the coredump, see the coredumpdelete. NOTE: To use this subcommand, you must have the Execute Debug privilege. Synopsis racadm coredump Example • racadm coredump There is no coredump currently available. • racadm coredump Feb 19 15:51:40 (none) last message repeated 5 times Feb 19 15:52:41 (none) last message repeated 4 times Feb 19 15:54:12 (none) last message repeated 4 times Feb 19 15:56:11 (none) last message repeated 2 times Feb 22 11:46:11 (none) kernel: coredumpdelete Table 16. Details of coredumpdelete Description Deletes any currently available coredump data stored in the RAC. To use this subcommand, you must have Execute Debug Command permission. NOTE: If a coredumpdelete command is issued and a coredump is not currently stored in the RAC, the command displays a success message. This behavior is expected. See the coredump subcommand for more information about viewing a coredump. Synopsis racadm coredumpdelete Output Example Coredump is deleted. racadm coredumpdelete Coredump request completed successfully 52 RACADM Subcommand Details