Dell PowerEdge T140 EMC Technical Specifications - Page 10
Drive specifications, Drives, Optical drives, Ports and connectors specifications
View all Dell PowerEdge T140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Drive specifications Drives The Dell EMC PowerEdge T140 system supports: • 4 x 3.5-inch SAS, SATA drives NOTE: For a system with 4 TB (or more) drive capacity, PERC is required for thermal control. Optical drives The Dell EMC PowerEdge T140 system supports the following optical drives. Table 8. Supported optical drive type Supported drive type Dedicated SATA DVD-ROM drive or DVD +/-RW drive Supported number of drives One Ports and connectors specifications USB ports specifications Table 9. Dell EMC PowerEdge T140system USB port specifications Front panel Back panel • One USB 3.0-compliant ports • One micro USB 2.0-compliant port for iDRAC Direct NOTE: The micro USB 2.0 compliant port can only be used as an iDRAC Direct or a management port. • Two USB 3.0-compliant ports • Four USB 2.0-compliant ports Internal USB • One internal USB 3.0-compliant port NIC ports specifications The Dell EMC PowerEdge T140 system supports up to two 10/100/1000 Mbps Network Interface Controller (NIC) ports that are located on the back panel. Serial connector specifications The Dell EMC PowerEdge T140 system supports one serial connector on the back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant. VGA ports specification The Dell EMC PowerEdge T140 system supports one 15-pin VGA port, on the back of the system. NOTE: The front VGA port is available only with the rack configuration. 10 Technical specifications