Dell PowerEdge Web Server Dell PowerEdge FTOS Command Line Reference Guide for - Page 144

www.dell.com | support.dell.com show config (from PROTOCOL LLDP mode) Displays the LLDP configuration. Syntax show config Command Modes PROTOCOL LLDP Example Figure 11-18. show config Command Example for a Selected VLAN FTOS(conf-lldp)#show conf ! protocol lldp FTOS(conf-lldp)# show interfaces Displays information on a specific physical interface or virtual interface. Syntax show interfaces interface Parameters interface Enter one of the following keywords and slot/port or number information: • For the management interface on the stack-unit, enter the keyword managementethernet followed by slot/port information. The slot and port range is 0. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. • For a Port Channel interface, enter the keyword port-channel followed by a number. Range: 1-128 Command Modes EXEC EXEC Privilege Command History Usage Information Version 8.3.17.0 Supported on M I/O Aggregator Use this show interfaces command for details on a specific interface. Use the show interfaces stack-unit command for details on all interfaces on the designated stack unit. On the M I/O Aggregator, the show interface output displays incorrect rate information details over time for link monitoring when the rate-interval is configured for 5 seconds. Dell Force10 recommends using higher rate-intervals such as 15 to 299 seconds to minimize the errors seen. Note: In the CLI output, the power value will be rounded to a 3-digit value. For receive/ transmit power that is less than 0.000, an snmp query will return the corresponding dbm value even though the CLI displays as 0.000. 142 | Interfaces