Dell PowerVault MD3260 Owner's Manual - Page 22
Controller Module—Additional Features, Battery Backup Unit, Storage Array Thermal Shutdown
View all Dell PowerVault MD3260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Item Indicator, Button, or Connector Icon Description Off Indicates that you cannot remove the expansion module from the system. Controller Module-Additional Features Battery Backup Unit Each controller contains a two-cell Lithium ion nanopolymer battery backup unit (BBU). It provides power to the controller module in the event of a power outage. NOTE: For virtual disks, the controller firmware changes the data cache setting based on the state of the battery. If the battery is missing or does not have sufficient charge, the controller flushes the cache and sets the write cache attribute to Write Through for all virtual disks. When the battery is replaced, Write Back is re-enabled. Storage Array Thermal Shutdown The system automatically shuts down when system temperature exceeds the safe threshold. The battery backup unit protects against data loss by providing power to offload cache to non-volatile memory in the event of power loss. Temperature threshold values determine the temperature at which shutdown occurs. These thresholds cannot be changed. NOTE: It is not necessary to shut down any expansion enclosures attached to the storage array when thermal shutdown occurs. Table 2. Shutdown Threshold Type Threshold Temperature Exceeding Event Description Nominal failure threshold A critical event is set Maximum failure threshold Shutdown of the system power supplies occurs within 3 minutes Shutdown threshold Shutdown of the system power supplies occurs within 5 seconds System Password Reset To reset the password, push and hold down the password reset switch for at least five seconds. The password is deleted. You can change the password using MD Storage Manager. For more information about setting your password, see the Dell PowerVault MD3260/3260i/3660i/3660f/3060e Storage Arrays Administrator's Guide at support.dell.com/manuals. NOTE: If your system is iSCSI based, you can use the Modular Disk Configuration Utility to reset the system password. NOTE: The reset switch can be accessed by using a small object such as the tip of a pen. 22