Dell PowerVault NX3000 Hardware Owner's Manual - Page 157
and capacity. See Installing Memory Modules., See General Memory Module Installation Guidelines.
View all Dell PowerVault NX3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
Go to step 14 if an error message appears indicating a fault with a specific memory module. 4 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen." Make any changes to the memory settings, if needed. If the memory settings match the installed memory but a problem is still indicated, go to step 14. 5 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 6 Open the system. See "Opening the System." 7 Remove the cooling shroud. See "Removing the Cooling Shroud." 8 Check the memory channels and ensure that they are populated correctly. See "General Memory Module Installation Guidelines." 9 Reseat the memory modules in their sockets. See "Installing Memory Modules." 10 Replace the cooling shroud. See "Installing the Cooling Shroud." 11 Close the system. See "Closing the System." 12 Reconnect the system to its electrical outlet, and turn on the system and attached peripherals. 13 Enter the System Setup program and check the system memory setting. See "Memory Settings Screen." If the problem is not resolved, proceed with the next step. 14 Turn off the system and attached peripherals, and disconnect the system from the power source. 15 Open the system. See "Opening the System." 16 Remove the cooling shroud. See "Removing the Cooling Shroud." 17 If a diagnostic test or error message indicates a specific memory module as faulty, swap or replace the module. 18 To troubleshoot an unspecified faulty memory module, replace the memory module in the first DIMM socket with a module of the same type and capacity. See "Installing Memory Modules." 19 Replace the cooling shroud. See "Installing the Cooling Shroud." Troubleshooting Your System 157