Dell PowerVault NX3000 Hardware Owner's Manual - Page 51
Warning! No micro, Warning: A fatal
View all Dell PowerVault NX3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Table 1-2. System Messages (continued) Message Causes Corrective Actions Unused memory The memory configuration is Reconfigure the memory for detected. DIMM's not optimal for mirroring or Memory Mirroring or installed in the Advanced ECC Memory Advanced ECC Memory following slot Mode. Modules in the Mode, or change the memory are not available specified slots are unused. mode to Optimized in the when in mirror or BIOS setup screen. See 128-bit advanced "System Memory." ECC modes: x,x,x Warning: A fatal A fatal system error occurred Check the SEL for error has caused and caused the system to information that was logged system reset! reboot. during the error. See the Please check the applicable troubleshooting system event log! section in "Troubleshooting Your System" for any faulty components specified in the SEL. Warning: Control Panel is not installed. The control panel is not Install the control panel, or installed or has a faulty cable check the cable connections connection. between the display module, the control panel board, and the system board. See "Control Panel Assembly (Service-only Procedure)." Warning! No micro Micro code update failed. code update loaded for processor n Update the BIOS firmware. See "Getting Help." About Your System 51