Dell PowerVault NX3000 Hardware Owner's Manual - Page 24
Table 1-1., LCD Status Messages, Cause, Corrective Actions, E1114 Ambient Temp
View all Dell PowerVault NX3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
NOTE: The following LCD status messages are displayed in the Simple format. See "Setup Menu" to select the format in which the messages are displayed. Table 1-1. LCD Status Messages Code Text E1000 Failsafe voltage error. Contact support. E1114 Ambient Temp exceeds allowed range. E1116 Memory disabled, temp above range. Power cycle AC. E1210 Motherboard battery failure. Check battery. E1211 RAID Controller battery failure. Check battery. E1216 3.3V Regulator failure. Reseat PCIe cards. Cause Corrective Actions Check the system event log Remove AC power to the for critical failure events. system for 10 seconds and restart the system. If the problem persists, see "Getting Help." Ambient temperature has a See "Troubleshooting reached a point outside of System Cooling the allowed range. Problems." Memory has exceeded allowable temperature and has been disabled to prevent damage to the components. Remove AC power to the system for 10 seconds and restart the system. See "Troubleshooting System Cooling Problems." If the problem persists, see "Getting Help." CMOS battery is missing or See "Troubleshooting the the voltage is outside of the System Battery." allowable range. RAID battery is either missing, bad, or unable to recharge due to thermal issues. Reseat the RAID battery connector. See "Installing a RAID Battery" and "Troubleshooting System Cooling Problems." 3.3V voltage regulator has failed. Remove and reseat the PCIe expansion cards. If the problem persists, see "Troubleshooting Expansion Cards." 24 About Your System