Dell Powerconnect W-ClearPass Hardware Appliances W-CP500 Hardware Installatio - Page 10

6B. 2-Post Rack Installation Unpack the appliance and locate the mounting hardware Step 1 • Remove the inner fixed chassis rails from the outer fixed chassis rails. • Pull each one out as far as possible. • Depress the locking tab to pull the inner rail completely out. • Put these rails aside for later installation on the appliance. Step 2 • Attach the long fixed (A) and the small (B) brackets to the 2-post rack. • Mount the short brackets in the front, and the longer brackets in the back using two M5 x 12* flat head screws and cone washers for each bracket as shown, using the top and bottom holes. • Make sure the brackets and screws are aligned in the rack not only in the front and back, but are level in height on the left and right sides for proper alignment to allow accurate appliance installation. Step 3 • Slide each of the outer fixed chassis rails into the left and right fixed brackets and loosely secure with four M4 x 4 truss head screws on each side (shown with red dotted lines). • Leave enough of the outer fixed rails extended in the front to attach fixed rack brackets (C) to the rack rails using two M4 x 4 truss head screws on each side (shown with the blue dotted lines). There should be approximately one inch of space between brackets (B) and (C) in the front. • Once all screws are in place, tighten each one to secure the outer fixed chassis rails in place. * NOTE: Use the hardware supplied with your specific rack if different from the hardware supplied in this kit. Once you have completed mounting the brackets and outer fixed chassis rails to the 2-post rack, proceed to Section 7 on page 10, Rail Installation on the Appliance. W-ClearPass 500 Hardware Installation Guide 10