Dell Powerconnect W-ClearPass Hardware Appliances W-CP500 Hardware Installatio - Page 5

Electrical and General Safety, Guidelines

Page 5 highlights

3. Electrical and General Safety Guidelines CAUTION This appliance is intended for installation in restricted areas only. Initial setup and maintenance should be performed by qualified personnel. CAUTION Power down the appliance following the operating system's proper power down procedure from the front panel. Unplug all AC power cord(s) before servicing. CAUTION To avoid electrical shock, check the power cords as follows.  This product is to be installed in Restricted Access Location only.  Use the exact type of power cords required.  Use power cord(s) that came with safety certifications.  Power cord(s) must comply with AC voltage requirements in your region.  The power cord plug cap must have an electrical current rating that is at least 125% of the electrical current rating of this product.  The power cord plug cap that plugs into the AC receptacle on the power supply must be an IEC  320, sheet C13, type female connector.  Plug the power cord(s) into a socket that is properly grounded before turning on the power. CAUTION Required operating conditions for the appliance are  Temperature: 10 to 35oC.  Humidity, non-condensing: 8 to 90%. CAUTION Risk of explosion if the battery is installed upside down or is replaced by an incorrect type. Dispose of used batteries according to the instructions. DISPOSING OF BATTERY BACKUP UNITS - IF APPLICABLE WARNING If the BBU is damaged in any way, toxic chemicals may be released. The material in the battery pack contains heavy metals that can contaminate the environment. Federal, state, and local regulations prohibit the disposal of rechargeable batteries in public landfills. Be sure to recycle the old battery packs properly. Comply with all applicable battery disposal and hazardous material handling laws and regulations in the country or other jurisdiction where you are using the BBU. WARNING There is danger of an explosion if the battery is incorrectly replaced. Replace it only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's instructions. W-ClearPass 500 Hardware Installation Guide 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13

W-ClearPass 500 Hardware Installation Guide
5
3.
Electrical and General Safety
Guidelines
CAUTION
This appliance is intended for installation in restricted areas only. Initial setup and maintenance should be
performed by qualified personnel.
CAUTION
Power down the appliance following the operating system’s proper power down procedure from the front
panel. Unplug all AC power cord(s) before servicing.
CAUTION
To avoid electrical shock, check the power cords as follows.
This product is to be installed in Restricted Access Location only.
Use the exact type of power cords required.
Use power cord(s) that came with safety certifications.
Power cord(s) must comply with AC voltage requirements in your region.
The power cord plug cap must have an electrical current rating that is at least 125% of the electrical
current rating of this product.
The power cord plug cap that plugs into the AC receptacle on the power supply must be an IEC
320, sheet C13, type female connector.
Plug the power cord(s) into a socket that is properly grounded before turning on the power.
CAUTION
Required operating conditions for the appliance are -
Temperature: 10 to 35
o
C.
Humidity, non-condensing: 8 to 90%.
CAUTION
Risk of explosion if the battery is installed upside down or is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
DISPOSING OF BATTERY BACKUP UNITS - IF APPLICABLE
WARNING
If the BBU is damaged in any way, toxic chemicals may be released.
The material in the battery pack contains heavy metals that can contaminate the environment. Federal, state,
and local regulations prohibit the disposal of rechargeable batteries in public landfills. Be sure to recycle the
old battery packs properly. Comply with all applicable battery disposal and hazardous material handling laws
and regulations in the country or other jurisdiction where you are using the BBU.
WARNING
There is danger of an explosion if the battery is incorrectly replaced. Replace it only with the same or
equivalent type recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.