Dell Precision 410 Dell Precision WorkStation 410 Mini Tower Systems User's Gu - Page 31
NOTE: A Display Power Management Signaling DPMS monitor does
View all Dell Precision 410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
The computer's front panel contains the following indicators and controls (see Figure 1-2): The power button provides control of the system's alternating current (AC) input power. The push-button switch operates as follows: - When the computer is turned off, pressing the button turns the computer on. - When the computer is turned on, pressing the button turns the computer off. However, a low-voltage (standby) current is maintained by the power supply. To completely remove all power from the system, unplug the AC power cable from its source. For systems running Microsoft Windows 95 or Windows NT with the Dell AutoShutdown service operational, pressing the power button causes the system to perform an orderly operating system shutdown before turning off. (For more information, see "Dell AutoShutdown Service" in Chapter 2.) NOTE: A Display Power Management Signaling (DPMS) monitor does not begin warming up until the computer to which it is attached is turned on. Thus, some DPMS monitors may not display a video image until several seconds after you turn on the computer. The power indicator light is green during normal system operation and amber when the computer is in sleep mode. The hard-disk drive access indicator lights up when a hard-disk drive is in use. (Drive access indicators for diskette drives and tape drives are located on the front of the drives.) The reset button reboots (restarts) the system without your having to turn the power off and then on again. Rebooting the system in this manner reduces stress on system components. Introduction 1-9