Dell Precision 5540 Service Manual - Page 19

Disassembly and reassembly, Base cover, Installing the Base Cover

Get Dell Precision 5540 PDF manuals and user guides View all Dell Precision 5540 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 19 highlights

4 Disassembly and reassembly Disassembly and reassembly Base cover Installing the Base Cover 1. Place the base cover on the computer and snap it in place. 2. Tighten the M2x3 T5 (10), M2x8 (2) screws to secure the base cover to the computer. NOTE: Ensure you use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8 system badge screws. 3. Turn the system badge flap over and snap it in place. 4. Follow the procedures in After Working Inside Your Computer. Removing the Base Cover 1. Follow the procedures in Before Working Inside Your Computer. 2. Close the display and turn the computer over. 3. Turn the system badge flap over and then remove the M2x3 T5 (10), M2x8.5 (2) screws that secure the base cover to the computer [1,2]. NOTE: Use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8.5 screws inside the badge flap. 4. Pry the edges of the base cover and lift it to remove it from the computer. Disassembly and reassembly 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
Disassembly and reassembly
Disassembly and reassembly
Base cover
Installing the Base Cover
1.
Place the base cover on the computer and snap it in place.
2.
Tighten the M2x3 T5 (10), M2x8 (2) screws to secure the base cover to the computer.
NOTE:
Ensure you use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8 system
badge screws.
3.
Turn the system badge flap over and snap it in place.
4.
Follow the procedures in
After Working Inside Your Computer
.
Removing the Base Cover
1.
Follow the procedures in
Before Working Inside Your Computer
.
2.
Close the display and turn the computer over.
3.
Turn the system badge flap over and then remove the M2x3 T5 (10), M2x8.5 (2) screws that secure the base cover to the computer
[1,2].
NOTE:
Use a Torx #5 screwdriver for the base screws and a Philips screwdriver for the two M2x8.5 screws inside the
badge flap.
4.
Pry the edges of the base cover and lift it to remove it from the computer.
4
Disassembly and reassembly
19