Dell UP3017Q User Guide - Page 50
Power Save, If either DP, mDP, HDMI1 or HDMI2 input is selected and the corresponding cable is
View all Dell UP3017Q manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
When the monitor enters the Power Save mode, the following message appears: Dell UltraSharp UP3017 Entering Power Save Mode. Activate the computer and wake up the monitor to gain access to the OSD. If you press any button other than the power button, the following messages will appear depending on the selected input: Dell UltraSharp UP3017 No DP signal from your device. Press any key on the keyboard or move the mouse or wake it up. If there is no display, press the monitor button again to select the correct input source. If either DP, mDP, HDMI1 or HDMI2 input is selected and the corresponding cable is not connected, a floating dialog box as shown below appears. Dell UltraSharp UP3017 ? No DP Cable The display will go into Power Save Mode in 4 minutes. www.dell.com/support/monitors or Dell UltraSharp UP3017 ? No mDP Cable The display will go into Power Save Mode in 4 minutes. www.dell.com/support/monitors 50 | Operating the Monitor