Dell Vostro A860 Service Manual - Page 17
Display Panel Cable, Display Inverter
View all Dell Vostro A860 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
3. Align the display panel with the display cover and replace the six screws. 4. Connect the display cables to the ends of the inverter board. 5. Route the cables back through their routing channels. 6. Replace the display bezel (see Replacing the Display Bezel). 7. Replace the display assembly (see Display). Display Panel Cable NOTE: The Display Panel cables and connectors may differ depending on the Display Panel you ordered. Removing the Display Panel Cable 1. Remove the display assembly (see Display). 2. Remove the display bezel (see Removing the Display Bezel). 3. Remove the display panel (see Removing the Display Panel). 4. Turn over the display panel and remove the conductive tape on the display board. 5. Disconnect the flex cable from the display board. 1 display board connector 3 conductive tape 2 flex cable Replacing the Display Panel Cable CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance. 1. Connect the flex cable to the connector on the inverter board. 2. Connect the flex cable to the connector on the back of the display panel and adhere the tape back into position. 3. Replace the display panel (see Replacing the Display Panel). 4. Replace the display bezel (see Replacing the Display Bezel). 5. Replace the display assembly (see Replacing the Display Assembly). Display Inverter