Dell W-7005 AOS 6.4.x CLI Reference Guide - Page 2263

Parameter beacon-table passive clone bcn-req-chan-11a bcn-req-chan-11bg bcn-req-time dot11k-enable force-dissasoc Description Enables beacon-table beacon measurement mode.In this mode, the client measures beacons and returns a report with stored beacon information for any supported channel with the requested SSID and BSSID. The client does not perform any additional measurements. This is the default beacon measurement mode. Default - NOTE: If a station doesn't support beacon-table able measurement mode, it returns a Beacon Measurement Report with the Incapable bit set in the Measurement Report Mode field. Enables passive beacon measurement mode. In this mode, - the client sets a measurement duration timer, and, at the end of the measurement duration, compiles all received beacons or probe response with the requested SSID and BSSID into a measurement report. NOTE: If a station doesn't support passive measurement mode, it returns a Beacon Measurement Report with the Incapable bit set in the Measurement Report Mode field. Copy settings from another specified 802.11k profile. - This value is sent in the 'Channel' field of the beacon 36 requests on the 'A' radio. You can specify values in the range 34 to 165. This value is sent in the 'Channel' field of the Beacon 1 Requests on the 'BG' radio. You can specify values in the range 1 to 14. This option configures the time duration between two consecutive beacon requests sent to a dot11K client. By default, the beacon requests are sent to a dot11K client every 60 seconds. However, if a different value is required, the bcn-req-time option can be used. This permits values in the range from 10 seconds to 200 seconds. 60 seconds Enables the 802.11K feature. This feature is disabled by default. Disabled This feature allows the AP to forcefully disassociate "onhook" voice clients (clients that are not on a call) after period of inactivity. Without the forced disassociation feature, if an AP has reached its call admission control limits and an on-hook voice client wants to start a new call, that client may be denied. If forced disassociation is enabled, those clients can associate to a neighboring AP that can fulfil their QoS requirements. Disabled This feature is disabled by default. 2263 | wlan dot11k-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide