Dell W-7005 AOS 6.4.x CLI Reference Guide - Page 2317

Parameter stbc-tx-streams supported-mcsset Description will be disabled for disabled for beamformed frames. Controls the maximum number of spatial streams usable for STBC transmission. 0 disables STBC transmission, 1 uses STBC for MCS 0-7. Higher MCS values are not supported. (Supported on WAP90 series, W-AP175, W-AP130 Series and WAP105 only. The configured value will be adjusted based on AP capabilities.) NOTE: If transmit beamforming is enabled, STBC will be disabled for disabled for beamformed frames. Comma-separated list of Modulation Coding Scheme (MCS) values or ranges of values to be supported on this high-throughput SSID. Range Default 0-1 1 0-23 0-23 temporal-diversity Shows if temporal diversity has been enabled or dis- - abled. When this feature is enabled and the client is not responding to 802.11 packets, the AP will launch two hardware retries; if the hardware retries are not successful then it attempts software retries. disabled very-high-throughputenable Enable or disable support for Very High Throughput - (802.11ac ) on the SSID. enabled vht-supported-mcs-map Modulation Coding Scheme (MCS) values or ranges of values for spatial streams 1 through 3. Valid values for the maximum MCS settings are 7, 8, 9 or a dash (-) if a spatial stream is not supported. If a MCS is not valid for a particular combination of bandwidth and number of spatial streams, it will not be used. 7, 8, 9, or - Default: 9,9,9 vht-txbf-explicit-enable Enable or disable VHT Explicit Transmit Beam- - forming for the W-AP220 Series . When this feature is enabled, the AP requests information about the MIMO channel and uses that information to transmit data over multiple transmit streams using a calculated steering matrix. The result is higher throughput due to improved signal at the beamformee (the receiving cli- ent). If this parameter is disabled, all other transmit beamforming settings will not take effect. Enabled vht-txbf-sounding-interval Time interval in seconds between channel information updates between the AP and the beamformee client. (W-AP220 Series only) 1-1000 25 seconds seconds Usage Guidelines The ht-ssid profile configures the high-throughput SSID. Stations are not allowed to use HT with TKIP standalone encryption, although TKIP can be provided in mixed-mode BSSIDs that support HT. HT is disabled on a BSSID if the encryption mode is standalone TKIP or WEP. You can also use this profile to configure explicit transmit beamforming for W-AP130 Series access points. When this feature is enabled, the AP coordinates the signals sent from each antenna so the signals focus on the receiver, improving radio range and performance. The W-AP130 Series AP can advertise transmit beamforming 2317 | wlan ht-ssid-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide