Dell W-7030 AOS 6.4.x Quick Start Guide - Page 6

Table 4 Serial Console Configuration Dialog (Continued) Console Prompt Description Enter the VLAN 1 interface IPv6 address [2000::1]: NOTE: This prompt is not applicable if the switch role is branch. The controller takes its IP address from VLAN 1 and uses this IP address to communicate with other controllers and with APs. Supported subnets are: Global Unicast: 2000::/3, Unique local unicast: fc00::/7 Enter an IPv6 VLAN 1 interface IP address, or press Enter without specifying an IP address to use the default address 2000::1. Enter VLAN 1 interface IPv6 prefix length [64]: NOTE: This prompt is not applicable if the switch role is branch. Enter a value from 0 to 128 to define an IPv6 VLAN 1 interface IP prefix length, or press Enter without specifying a prefix length to use the default value of 64. Enter IPv6 default gateway [none]: NOTE: This prompt is not applicable if the switch role is branch. This optional value is usually the IP address of the interface on the upstream switch or router to which you will connect the controller. The default gateway and the VLAN 1 IP address need to be in the same network. Enter an IPv6 gateway IP address to configure this setting, or press Enter to continue without specifying an IP gateway. Enter Branch Master switch IP address NOTE: This prompt is applicable only if the switch role is branch. Enter the IP address of the branch master controller. Enter branch master switch IP address or FQDN Enter Branch wired uplink port [GE 1/0] NOTE: This prompt is applicable only if the switch role is branch. Its not value 1 or 0, value should be 1/0 or 0/0/0 or any port based on the controller platform Enter Branch wired-vlan Type (pppoe|dhcp|static) [static] NOTE: This prompt is applicable only if the switch role is branch. Enter the type of the branch wired VLAN. This controller is restricted to Country code US for United States, please confirm (yes|no) If your controller has a country code that restricts its usage, enter yes to confirm this code. Enter Time Zone Enter the time zone for the controller, or press Enter to select the default time zone. Enter Time in UTC Enter the current time in UTC format, or press Enter to select the default time. Enter Date (MM/DD/YYYY) Enter the current date, or press Enter to select the default date. Enter Password for admin login (up to 32 chars) NOTE: This prompt is not applicable if the switch role is branch. Enter a password to allow the admin user to login to the controller WebUI, CLI and console interfaces. This password can be up to 32 alphanumeric characters long. Enter Password for enable mode (up to 15 chars) NOTE: This prompt is not applicable if the switch role is branch. Enter a password for the admin user to access Enable mode in the controller WebUI, CLI and console interfaces. This password can be up to 15 alphanumeric characters. Do you wish to shutdown all the ports (yes|no)? [no] NOTE: This prompt is not applicable if the switch role is branch. Enter yes to shut down all ethernet ports on the controller, or press Enter to allow all ports to remain active. 6 Dell Networking W-Series ArubaOS 6.4.x | Quick Start Guide