Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 User Guide - Page 236

use tiebreaker: OFF peer profile: NOT SET session profile: NOT SET trace flags: PROTOCOL FSM API AVPDATA FUNC XPRT DATA SYSTEM CLI To view L2TPv3 system statistics: (Instant AP)# show l2tpv3 system statistics L2TP counters:Total messages sent: 99, received: 194, retransmitted: 0 illegal: 0, unsupported: 0, ignored AVPs: 0, vendor AVPs: 0 Setup failures: tunnels: 0, sessions: 0 Resource failures: control frames: 0, peers: 0 tunnels: 0, sessions: 0 Limit exceeded errors: tunnels: 0, sessions: 0 Frame errors: short frames: 0, wrong version frames: 0 unexpected data frames: 0, bad frames: 0 Internal: authentication failures: 0, message encode failures: 0 no matching tunnel discards: 0, mismatched tunnel ids: 0 no matching session_discards: 0, mismatched session ids: 0 total control frame send failures: 0, event queue fulls: 0 Message counters:Message RX Good RX Bad TX ILLEGAL 0 0 0 SCCRQ 0 0 1 SCCRP 1 0 0 SCCCN 0 0 1 STOPCCN 0 0 0 RESERVED1 0 0 0 HELLO 95 0 95 OCRQ 0 0 0 OCRP 0 0 0 OCCN 0 0 0 ICRQ 0 0 1 ICRP 1 0 0 ICCN 0 0 1 RESERVED2 0 0 0 CDN 0 0 0 WEN 0 0 0 SLI 0 0 0 Configuring Routing Profiles W-IAPs can terminate a single VPN connection on a Dell Networking W-Series Mobility Controller. The routing profile defines the corporate subnets which need to be tunneled through IPsec. You can configure routing profiles for policy based routing into the VPN tunnel using the Instant UI or the CLI. In the Instant UI To configure a routing profile: 1. Click Routing in the Tunneling window. The routing details are displayed. 2. Click New. The route parameters to configure are displayed. Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide VPN Configuration | 236