Dell W-Series 304 Instant 6.5.1.0-4.3.1.0 User Guide - Page 407
For information on controller configuration, see, deployments
View all Dell W-Series 304 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 407 highlights
Table 86: W-IAP Configuration for Scenario 3-IPsec: Multiple Datacenter Deployment Configuration Steps CLI Commands UI Procedure 10.16.0.0/16 network and all other traffic address is translated at the source and the global routing profile definition is bypassed. (Instant AP)(config)# wlan access-rule wireless-ssid (Instant AP)(Access Rule "wireless-ssid")# rule any any match any any any permit For WLAN SSID contractor roles: (Instant AP)(config)# wlan access-rule wirelessssid-contractor (Instant AP)(Access Rule "wireless-ssid-contractor") # rule 10.16.0.0 255.255.0.0 match any any any permit (Instant AP)(Access Rule "wireless-ssid-contractor") # rule any any match any any any src-nat NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and propagating changes across the W-IAP cluster. W-IAP-Connected Switch Configuration Client VLANs defined in this example must be opened on the upstream switches in multiple W-IAP deployments, as client traffic from the slave to the master is tagged with the client VLAN. Datacenter Configuration For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 243. The following OSPF configuration is required on the controller to redistribute IAP-VPN routes to upstream routers: (host)(config) # router ospf (host)(config) # router ospf router-id (host)(config) # router ospf area 0.0.0.0 (host)(config) # router ospf redistribute rapng-vpn 407 | IAP-VPN Deployment Scenarios Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide