Dell W-Series 324 Instant 6.4.3.1-4.2 User Guide - Page 219
Static IP, Finish, Table 41
View all Dell W-Series 324 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 219 highlights
Table 41: Distributed DHCP Mode Configuration Parameters Name Description Default router If Distributed, L2 is selected for type of DHCP scope, specify the IP address of the default router. DNS Server If required, specify the IP address of a DNS server. Domain Name If required, specify the domain name. Lease Time Specify a lease time for the client in minutes within a range of 2-1440 minutes. The default value is 720 minutes. IP Address Range Specify a range of IP addresses to use. To add another range, click the + icon. You can specify up to four different ranges of IP addresses. l For Distributed, L2 mode, ensure that all IP ranges are in the same subnet as the default router. On specifying the IP address ranges, a subnet validation is performed to ensure that the specified ranges of IP address are in the same subnet as the default router and subnet mask. The configured IP range is divided into blocks based on the configured client count. l For Distributed,L3 mode, you can configure any discontiguous IP ranges. The configured IP range is divided into multiple IP subnets that are sufficient to accommodate the configured client count. NOTE: You can allocate multiple branch IDs (BID) per subnet. The W-IAP generates a subnet name from the DHCP IP configuration, which the controller can use as a subnet identifier. If static subnets are configured in each branch, all of them are assigned the with BID 0, which is mapped directly to the configured static subnet. Option Specify the type and a value for the DHCP option. You can configure the organization-specific DHCP options supported by the DHCP server. For example, 176, 242, 161, and so on. To add multiple DHCP options, click the + icon. You can add up to eight DHCP options. 4. Click Next. 5. Specify the number of clients to use per branch. The client count configured for a branch determines the use of IP addresses from the IP address range defined for a DHCP scope. For example, if 20 IP addresses are available in an IP address range configured for a DHCP scope and a client count of 9 is configured, only a few IP addresses (in this example, 9) from this range will be used and allocated to a branch. The W-IAP does not allow the administrators to assign the remaining IP addresses to another branch, although a lower value is configured for the client count. 6. Click Next. The Static IP tab is displayed. Specify the number of first and last IP addresses to reserve in the subnet. 7. Click Finish. In the CLI To configure Distributed,L2 DHCP scope: (Instant AP)(config)# ip dhcp (Instant AP)(DHCP Profile )# ip dhcp server-type (Instant AP)(DHCP Profile )# server-vlan (Instant AP)(DHCP Profile )# subnet-mask (Instant AP)(DHCP Profile )# default-router Dell Networking W-Series Instant 6.4.3.1-4.2.0.0 | User Guide DHCP Configuration | 219