Denon AVR-1513 Owners Manual - Page 58

Basic version Advanced version GAudioH Symptom Cause/Solution Page Audio is not output. • Check the connections for all devices. C 4, 6, 7, 10, 11, 12, 13 • Check the speaker connections and configurations. C 3, 25, 26 • Check whether the audio device power is turned on. - • Adjust the master volume. 14 • Cancel the mute mode. 14 • Select a suitable input source. 14 • Select a suitable input mode. 33 • Disconnect the headphones. No sound is output from the 42 speakers when headphones are connected. The volume does not • The maximum volume is set too low. Set the maximum volume 34 increase. using "Limit" on the menu. • Power for external devices connected to the output connectors - of the unit may not be turned on. Check the power of connected external devices. No sound is produced from surround speaker. No sound is produced from subwoofer. • Check if the surround speakers are connected to the SURROUND - terminals. • Check the subwoofer connections. • Turn on the subwoofer's power. • Set "Speaker Config." - "Subwoofer" on the menu to "Yes". • If "Front" and "Center" for "Speaker Config." are set to "Large", and "SW Mode" is set to "LFE", no sound may be output from the subwoofers, depending on the input signal or selected surround mode. C 3, 25, 26 C 4 C 6 C 5, C 6 DTS sound is not • Set "Decode Mode" on the menu to "Auto" or "DTS". 33 output. Dolby TrueHD, DTSHD, Dolby Digital Plus audio is not output. Dolby PLg mode or DTS NEO:6 mode cannot be selected. • Make HDMI connections. • Check that "Speaker Config." - "Center" or "Surround" is set to other than "None". If the speaker system is 2.0/2.1ch, this surround mode cannot be selected. • When headphones are used, Dolby PLg or DTS NEO:6 cannot be selected. 6 C 5 - RESTORER cannot • Check that an analog signal or PCM signal (fs=44.1/48 kHz) is 39 be selected. input. For playback of multichannel signals such as Dolby Digital or DTS surround, RESTORER cannot be used. GRadioH Symptom Cause/Solution Reception fails, or there is a lot of noise or distortion. • Change the antenna orientation or position. • Separate the AM loop antenna from the unit. • Use an FM outdoor antenna. • Separate the antenna from other connection cables. GRemote Control UnitH Symptom Cause/Solution The set cannot be operated with the remote control unit. • Batteries are worn out. Replace with new batteries. • Operate the remote control unit within a distance of about 7 m from this unit and at an angle of within 30°. • Remove any obstacle between this unit and the remote control unit. • Insert the batteries in the proper direction, checking the q and w marks. • The set's remote control sensor is exposed to strong light (direct sunlight, inverter type fluorescent bulb light, etc.). Move the set to a place in which the remote control sensor will not be exposed to strong light. Page 13 13 13 13 Page 46 46 46 46 46 Information 55