Denon AVR-1513 Owners Manual - Page 59

Basic version Advanced version Resetting the microprocessor Perform this procedure if the display is abnormal or if operations cannot be performed. When the microprocessor is reset, all the settings are reset to their default values. X SOURCE SELECT 0 SOURCE SELECT 1 1 Turn off the power using X. 2 Press X while simultaneously pressing SOURCE SELECT 0 and SOURCE SELECT 1. 3 Once the display starts flashing at intervals of about 1 second, release the two buttons. If in step 3 the display does not flash at intervals of about 1 second, start over from step 1. Specifications nn Audio section • Power amplifier Rated output: Output connectors: • Analog Input sensitivity/Input impedance: Frequency response: S/N: nn Video section • Standard video connectors Input/output level and impedance: Frequency response: nn Tuner section Receiving Range: Usable Sensitivity: 50 dB Quieting Sensitivity: S/N: Total harmonic Distortion: nn General Power supply: Power consumption: Front: 75 W + 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) Center: 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) Surround: 75 W + 75 W (8 Ω, 20 Hz - 20 kHz with 0.08 % T.H.D.) 110 W + 110 W (6 Ω, 1 kHz with 0.7 % T.H.D.) 6 - 16 Ω 200 mV/47 kΩ 10 Hz - 100 kHz - +1, -3 dB (DIRECT mode) 98 dB (IHF-A weighted, DIRECT mode) 1 Vp-p, 75 Ω 5 Hz - 10 MHz - 0, -3 dB [FM] (Note: μV at 75 Ω, 0 dBf = 1 x 10-15 W) 87.5 MHz - 108.0 MHz 1.2 μV (12.8 dBf) MONO 2.8 μV (20.2 dBf) MONO 70 dB (IHF-A weighted, DIRECT mode) STEREO 67 dB (IHF-A weighted, DIRECT mode) MONO 0.7 % (1 kHz) STEREO 1.0 % (1 kHz) [AM] 522 kHz - 1611 kHz 18 μV AC 230 V, 50/60 Hz 330 W 0.5 W (Standby) For purposes of improvement, specifications and design are subject to change without notice. Information 56