Denon AVR-3808CI Owners Manual - English - Page 39

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting h Trigger Out 1 Select the conditions to turn on the trigger out 1 with respect to the zone, input source, surround mode. For details about the trigger out function, see page 21. j Trigger Out 2 This sets the conditions to turn on the trigger out 2, in the same way as "Trigger Out 1" above. [Selectable items] ON - - - Setting with Respect to the Zone • When the power of the zone turned on/off, the trigger out turns on. • Associated with the power supply of zones set to "ON". Setting with Respect to the Input Source • When the input source set to on is selected, the trigger out turns on. • Associated with respect to the input source for zones set to "ON" at "Setting with Respect to the Zone". Setting with Respect to the Surround Mode • When the surround mode set to on is selected, the trigger out turns on. • Associated with respect to surround modes that are set to "ON". • This can be set if the "MAIN ZONE" setting at "Setting with Respect to the Zone" is set to "ON". • Associated when an input source for which "Setting with Respect to the Input Source" is set to "ON" is selected. k Remote ID Set remote control ID. Match the ID setting of the remote control unit and the receiver. [Selectable items] 1 2 3 4 • When changing the remote ID, also change the AMP, iPod, TU and NET/DTU modes of the main remote control unit at the same time (vpage 62). • When changing the remote ID, also change the sub remote control unit at the same time (vpage 67). l 2Way Remote Make setting for 2-way remote control unit. [Selectable items] Used Not Used When using a 2-way remote control unit (RC-7000CI and RC-7001RCI, sold separately), set this to "Used". A0 Dimmer Adjust display brightness of the receiver. [Selectable items] Bright Dim Dark OFF Operating from the main unit Press the DIMMER button. Bright Dim OFF Dark A1 Setup Lock Protect settings from inadvertent change. [Selectable items] ON OFF • When "Setup Lock" is set to "ON", the settings listed below can no longer be changed. Also, "SETUP LOCKED!" is displayed if you attempt to operate related buttons. ⋅ GUI menu operations ⋅ RESTORER ⋅ Night Mode ⋅ Parameter ⋅ Room EQ ⋅ Channel Level ⋅ Audio Delay • To cancel the setting, press the MENU button to re-display the "Setup Lock" screen, then change the setting to "OFF". A2 Maintenance Mode This sets the function for maintenance by a DENON serviceperson or installer. (For professional use only.) This function allows a DENON serviceperson or installer to check the AVR-3808CI's status and make settings via the Internet. NOTE Only use this function if so instructed by a DENON serviceperson or installer. A3 Firmware Update Update the firmware of the receiver. Check for Update You can check for firmware updates. You can also check approximately how long it will take to complete an update. Start Execute the update process. When updating starts, the power indicator becomes red and the GUI screen is shut down. The amount of update time which has elapsed is displayed. When updating is complete the power indicator becomes green and normal status is resumed. b If the display reads as shown below, check the settings and network environment, then update again. Display Updating failed Description Updating failed. Login failed Failure to log into server. Server is busy Server is busy. Wait a while then try again. Connection fail Failure connecting to server. 36