Denon AVR-3808CI Owners Manual - English - Page 54

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting uiop ENTER [ iPod] ENTER [SEARCH] [CHANNEL +/-] [8], [9], [6], [7], [1], [2] uiop [iPod] (AMP mode) (Main remote control unit) [2] [8] [REPEAT] [1/3] [9] [RANDOM] (Sub remote control unit) About the button names in these explanations < > : Buttons on the main unit [ ] : Buttons on the remote control unit Button name only: Buttons on the main unit and remote control unit 51 iPod® Playback The music on an iPod can be played by using the Control Dock for iPod (ASD-1R, sold separately). The operation can also be performed using the buttons on the main unit or remote control unit while watching the GUI menus. iPod is a trademark of Apple Inc., registered in the U.S. and other countries. b The iPod may only be used to copy or play contents that are not copyrighted or contents for which copying or playback is legally permitted for your private use as an individual. Be sure to comply with applicable copyright legislation. Basic Operation 1 Make the necessary preparations. qSet the iPod in the DENON Control Dock for iPod. (vSee the Control Dock for iPod's operating instructions.) wAssign the Control Dock for iPod's input. : "Source Select" - "(input source)" - "Assign"- "iPod dock" (vpage 40) 2 Either turn or press [iPod] (AMP mode) to select the input source assigned in step 1-w above. OK to disconnect. (iPod screen) b If the screens above are not displayed, the iPod may not be properly connected. Try connecting again. : "Source Select" - "(input source)" - "Play" (vpage 38) 4 Press [SEARCH] and hold it down for a 2 seconds or more to select the display mode. To switch between modes, press and hold down the button. When remote mode is active, "Remote" is displayed. [Display mode] Browse mode Remote mode Display location Main unit display iPod display Playable Audio file S S files Video file A Sz Remote Active control unit S S buttons (AVR-3808CI) iPod A S z : V ideo may not be output, depending on the combination of ASD1R and iPod. • With the default settings, the iPod can be used connected to the VCR (iPod) connector. • Use the RESTORER mode to expand the low and high frequency components of compressed audio files and achieve a richer sound. The default setting is "Mode3". • Press and set the AVR-3808CI's power to the standby mode before disconnecting the iPod. Also switch the input source to one to which the GUI menu "iPod dock" is not assigned before disconnecting the iPod. NOTE • Depending on the type of iPod and the software version, some functions may not operate. • DENON will accept no responsibility whatsoever for any loss of iPod data. Listening to Music 1 Use ui to select the menu, then press ENTER or p to select the music file to be played. 2 Press ENTER or p. Playback starts. 3 To operate using the main remote control unit, set the remote control unit to the iPod mode. (vpage 59 "Remote Control Unit Operations") Stopping playback temporarily During playback, press ENTER or [1]. Press again to resume playback. Fast-forwarding or fast-reversing During playback, either press and hold u (to fast-reverse) or i (to fastforward), or press [6] or [7].