Denon AVR-591 Owners Manual - English - Page 14
Parameter Check, Error messages - surround system
UPC - 883795001335
View all Denon AVR-591 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
ENGLISH Error messages Parameter Check An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. Enables you to check the measurement results and equalizer If this happens, check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again. characteristics after Audyssey Auto Setup. NOTE Be sure to turn off the power before checking speaker connections. 1 Use ui to select "Parameter Check" and then press ENTER. Examples Caution MultEQ FMicrophone:None or Speaker :None Retry Cancel [ENT]:Retry Error details Measures • The connected setup microphone is broken, or a • Connect the included setup microphone to the device other than the supplied setup microphone SETUP MIC jack of this unit. is connected. • Not all speakers could be detected. • The front L speaker was not properly detected. • Check the speaker connections. 2 Use ui to select the item you want to check, then press ENTER. 3-2.Parameter Check Speaker Config.Check Distance Chenck Channel Level Check Crossover Freq.Check EQ Check Restore Caution MultEQ FAmbient noise is too high or Level is too low. Retry Cancel [ENT]:Retry Caution MultEQ Front R :None Retry Cancel Skip [ ]:Up/Down [ ]:CH • There is too much noise in the room for accurate • Either turn off any device generating noise or measurements to be made. move it away. • Perform again when the surroundings are quieter. • Speaker or subwoofer sound is too low for • Check the speaker installation and the direction accurate measurements to be made. in which the speakers are facing. • Adjust the subwoofer's volume. • The displayed speaker could not be detected. • Check the connections of the displayed speaker. [ENT]:Select [RTN]:Back Speaker Config. Check Check the speaker configuration. Distance Check Check the distance. Channel Level Check Check the channel level. Crossover Freq. Check Check the crossover frequency. EQ Check Check the equalizer. • If "EQ Check" is selected in step 2, press ui to select equalizing curve ("Audyssey" or "Audyssey Flat") to be checked. Use o p to switch the display between the different speakers. 3 Press RETURN. The confirmation screen reappears. Repeat steps 2 and 3. Caution MultEQ Front L :Phase Retry Cancel Skip [ ]:Up/Down [ ]:CH • The displayed is connected with the polarities • Check the polarities of the displayed speaker. reversed. • For some speakers, this error message may be displayed even if the speaker is properly connected. If you are sure the connection is correct, press ui to select "Skip", then press ENTER. Retrieving Audyssey Auto Setup settings If you set "Restore" to "Yes", you can return to Audyssey Auto Setup measurement result (value calculated at the start by MultEQ®) even when you have changed each setting manually. 10 Remote control operation buttons Move the cursor (Up/Down/Left/Right) Confirm the setting Return to previous menu