Denon DBP-1611UD Owner's Manual - English - Page 47
Operating range of the remote control, Inserting the batteries, Remote control settings remote - inside
UPC - 883795001618
View all Denon DBP-1611UD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
ENGLISH Remote control Inserting the batteries q Slide the rear lid in the direction of the arrow and remove it. w Load the two batteries properly as indicated by the marks in the battery compartment. R6/AA e Put the rear cover back on. Operating range of the remote control Point the remote control at the remote sensor when operating it. Approx. 23 ft /7 m 30° 30° Remote control settings (remote control side) Switches when this unit remote control operates another DENON BD players in the vicinity. Set the remote control code simultaneously on the main unit, too. "Remote ID" (vpage 37). 1 Hold POWER ON and OPEN/CLOSE pressed simultaneously. While these buttons are held pressed, the remote control signal transmission/status display flashes twice, and the remote control unit enters Setup mode. 2 DENON 1: Press "1". DENON 2: Press "2". If the battery level is low, the remote control signal transmission/ status display flashes 5 times when a button is pressed. In this case, replace the batteries soon. • If the batteries are completely exhausted, the remote control signal transmission/status indicator goes dark. NOTE The set may function improperly or the remote control may not operate if the remote control sensor is exposed to direct sunlight, strong artificial light from an inverter type fluorescent lamp or infrared light. When numeric key input is completed and the remote control signal transmission/status display flashes twice, the settings for the remote control are completed. NOTE • Insert the specified batteries in the remote control. • Replace the batteries with new ones if the set does not operate even when the remote control is operated close to the unit. (The supplied batteries are only for verifying operation.) • When inserting the batteries, be sure to do so in the proper direction, following the q and w marks in the battery compartment. • To prevent damage or leakage of battery fluid: • Do not use a new battery together with an old one. • Do not use two different types of batteries. • Do not attempt to charge dry batteries. • Do not short-circuit, disassemble, heat or dispose of batteries in flames. • If the battery fluid should leak, carefully wipe the fluid off the inside of the battery compartment and insert new batteries. • Remove the batteries from the remote control if it will not be in use for long periods. • Used batteries should be disposed of in accordance with the local regulations regarding battery disposal. If the signal code of the remote control does not match the signal code of the unit, the remote control code set on the unit is shown on the display. GExampleH If the code setting on the unit is "DENON 1", and the setting on the remote control is "2", "PLAYER 1" is shown on the display. NOTE • If you made the remote control settings incorrectly, the remote control signal transmission/status display flashes for 2 seconds, and then goes off. If this happens, the settings are incorrect and retry the settings. • Match the signal code of the remote control with the signal code of the unit. If the remote control code is different, you cannot operate the this unit with the remote control. • Even if you change the remote control code, set the GUI menu "Other Setup"-"Receive Legacy Remocon" (vpage 37) to "Off" when operating this unit with a remote control other than DENON's. 44