Denon DRA 685 Owners Manual - Page 10

ENGLISH Protector circuit • This unit is equipped with a high-speed protection circuit. This circuit protects the internal circuitry from damage due to large currents flowing if the speaker jacks are not completely connected or if an output is generated by a short circuit. In such a case, the protection circuit will operate to cut off the output to the speakers. Should this happen, turn the power off and check the speaker connections. Then turn the power on again. After muting for several seconds, the receiver should be operating normally. If the protection circuit is activated again even though there are no problems with the wiring or the ventilation around the unit, switch off the power and contact a DENON service center. Note on speaker impedance • The protector circuit may be activated if the set is played for long periods of time at high volumes when speakers with an impedance lower than the specified impedance (for example speakers with an impedance of lower than 4 Ω/ohms) are connected. If the protector circuit is activated, the speaker output is cut off. Turn off the set's power, wait for the set to cool down, improve the ventilation around the set, then turn the power back on. 6 PART NAMES AND FUNCTIONS Front Panel • For details on the functions of these parts, refer to the pages given in parentheses ( ). !7 !6 !5 !4 !3 !2 !1 B PRECISION AUDIO COMPONENT / AM-FM STEREO RECEIVER DRA-685 CD PHONO DVD / VDP TUNER REMOTE SENSOR V. AUX VCR STANDBY AUTO CH TONE SP-A TAPE MONITOR TUNING DOWN UP BAND MODE MEMORY SHIFT 1 2 TUNER 3 4 5 6 7 8 ON / STANDBY PHONES SPEAKER A B VIDEO SELECT MULTI SOURCE MODE SELECT TONE DEFEAT LOUDNESS BASS TREBLE VOLUME BALANCE L R qw e r t yu i o !0 q Power operation switch 17) w Headphone jacks (PHONES 22) e SPEAKER A/B buttons 17) r VIDEO SELECT button 22) t MULTI SOURCE buttons 19, 20) y TONE DEFECT button 18) u LOUDNESS button 18) i BASS adjustment control 18) o TREBLE adjustment control 18) !0 BALANCE control 18) !1 VOLUME control 18) !2 Preset memory selector buttons 26) !3 Display !4 Power indicator 17) !5 Remote control sensor (REMOTE SENSOR 12) !6 TUNING buttons 25, 26) !7 Input source selector buttons 18) 10