Dewalt DWE402N Instruction Manual - Page 12
Mounting Guard
View all Dewalt DWE402N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
4-1/2" (115 mm) Grinding Wheels Wire Wheels Sanding Discs English Type 27 guard Type 27 guard Type 27 guard Type 27 guard rubber backing pad unthreaded backing flange Type 27 hubbed wheel 3" (76.2 mm) wire cup brush 4" (100 mm) wire wheel sanding disc clamp nut Type 27 depressed center wheel threaded locking flange Mounting Guard CAUTION: Guards must be used with all grinding wheels, cutting wheels, sanding flap discs, wire brushes, and wire wheels. The tool may be used without a guard only when sanding with conventional sanding discs. A Type 1 guard (intended for use with Type 1 cutting wheels and Type 27 wheels marked for cutting only) is available at extra cost from your local dealer or authorized service center. Grinding with wheels other than Type 27 and Type 29 require different accessory guards not included with the tool. A type 27 guard is provided for use with a 1/4" (6.35 mm) thick Type 27 wheel. NOTE: Edge grinding and cutting can be performed with Type 27 wheels designed and specified for this purpose; 1/4" (6.35 mm) thick wheels are designed for surface grinding while thinner Type 27 wheels need to be examined for the manufacturer's label to see if they can be used for surface grinding or only edge grinding/cutting. A Type 1 guard must be used for any wheel where surface grinding is forbidden. Cutting can also be performed by using a Type 1 wheel and a Type 1 guard. MOUNTING, ADJUSTING AND REMOVING (TYPE 27) ONE-TOUCH™ GUARD (FIG. 3) Your grinder is supplied with a keyless ONE TOUCH™ guard. 1. Press the guard release lever (J). 2. While holding the guard release lever open, align the lugs (L) on the guard with the slots (M) on the gear case. 3. Keeping the guard release lever open, push the guard down until the guard lugs engage and rotate them in the groove on the gear case hub. Release the guard release lever. 10