Dewalt DWE402N Instruction Manual - Page 21

MOUNTING TYPE 1 OR TYPE 41 CUTTING WHEELS 4. Remove the tool from work surface before turning tool off. Allow WARNING: To reduce the risk of serious personal injury, turn the tool to stop rotating before setting it down. English tool off before making any adjustments or removing/installing attachments or accessories. An accidental start-up can cause injury. CAUTION: Matching diameter backing flange and threaded locking flange (included with tool) must be used for Type 1 and Type 41 cutting wheels. MAINTENANCE WARNING: To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury. 1. Place the unthreaded backing flange on spindle with the raised Cleaning section (pilot) facing up. The raised section (pilot) on the backing WARNING: Blow dirt and dust out of all air vents with clean, dry air flange will be against the wheel when the wheel is installed. at least once a week. To minimize the risk of eye injury, always wear 2. Place the wheel on the backing flange, centering the wheel on the ANSI Z87.1 approved eye protection when performing this. raised section (pilot). WARNING: Never use solvents or other harsh chemicals for 3. Install the threaded locking flange with the raised section (pilot) facing away from the wheel. 4. Depress the spindle lock button and tighten threaded locking flange with a wrench. cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. 5. To remove the wheel, depress the spindle lock button and loosen the threaded locking flange with a wrench. Accessories WARNING: Since accessories, other than those offered by USING TYPE 1 OR TYPE 41 CUTTING WHEELS DEWALT, have not been tested with this product, use of such WARNING: Do not use edge grinding/cutting wheels for surface accessories with this tool could be hazardous. To reduce the risk of grinding applications because these wheels are not designed for side injury, only DEWALT recommended accessories should be used with pressures encountered with surface grinding. Wheel breakage and this product. injury may result. Recommended accessories for use with your tool are available at 1. Allow tool to reach full speed before touching tool to work extra cost from your local dealer or authorized service center. If you surface. need assistance in locating any accessory, please contact DEWALT 2. Apply minimum pressure to work surface, allowing tool to operate Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286, at high speed. Cutting rate is greatest when the tool operates at call 1-800-4-DEWALT (1-800-433-9258) or visit our website: www. high speed. dewalt.com. 3. Once a cut is begun and a notch is established in the workpiece, do not change the angle of the cut. Changing the angle will cause the wheel to bend and may cause wheel breakage. 19