Dewalt DXCMH9919910 Instruction Manual - Page 16
Maintenance Chart
View all Dewalt DXCMH9919910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English AUTO OPEN MAINTENANCE Maintenance Chart Procedure Check safety valve Inspect air filter X X+ Daily Weekly Monthly 1 year or 200 Hours See tank warning label FIG. 3 OFF CLOSE Drain air tank X Check pump oil level Change pump oil X X **+ Oil leak inspection X Inspect drive belt X Check drive belt tension X Check pulley/flywheel alignment X Check for unusual noise/vibration X Check for air leaks X* Clean compressor exterior X Remove tank from service X++ * To check for air leaks apply a solution of soapy water around joints. While compressor is pumping to pressure and after pressure cuts out, look for air bubbles to form. ** The pump oil must be changed after the first 20 hours or operation. Thereafter, when using synthetic blend non-detergent air compressor oil, change oil every 200 hours of operation or once a year, whichever comes first. + Perform more frequent in dusty or humid conditions. ++ For more information, call 1-888-895-4549 . WARNING: Risk of unsafe operation. Unit cycles automatically when power is on. When performing maintenance, you may be exposed to voltage sources, compressed air, or moving parts. Personal injuries can occur. Before performing any maintenance or repair, disconnect power source from the compressor and bleed off all air pressure. To ensure efficient operation and longer life of the air compressor outfit, a routine maintenance schedule should be prepared and followed. The following routine maintenance schedule is geared to an outfit in a normal working environment operating on a daily basis. 16