Dewalt DXCMH9919910 Instruction Manual - Page 25
Troubleshooting Codes
View all Dewalt DXCMH9919910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
English Restricted air intake...9 Oil in discharge air...9, 19, 31 Knocking Noise...4, 10, 11, 12, 13, 14 Excessive belt wear...10, 11, 14, 15 Squealing sound...10 Moisture in pump crankcase...1, 3, 8, 17, 18, 19, 20, 21, 22 Excessive current draw...14, 23, 24 Compressor won't start in cold temperatures 17, 31, 32 Compressor stalls...25, 26, 27 Overheating...24, 30, 31 CODE POSSIBLE CAUSE 1 Fittings are not tight 2 Defective air tank 3 Leaking seals 4 Defective safety valve 5 Prolonged excessive use of air Troubleshooting Codes POSSIBLE SOLUTION Tighten fittings where air can be heard escaping. Check fittings with soapy water solution. DO NOT OVERTIGHTEN. Air tank must be replaced. Do not repair the leak. WARNING: Risk of bursting. Do not drill into, weld or otherwise modify air tank or it will weaken. The air tank can rupture or explode. Contact a DeWALT factory service center or a DeWALT authorized service center. Operate safety valve manually by pulling on ring. If valve still leaks, it must be replaced. Decrease amount of air usage. 25