Dymo Rhino 5200 Hard case Kit by DYMO User Guide - Page 4

3. Close the battery compartment door. 4. To charge the battery pack, connect the AC adapter as described below. Connecting the AC Adapter An optional AC power adapter can also be used to power the printer. Connecting the AC adapter to the printer disconnects the batteries as a power source. To connect the AC adapter 1. Plug the power adapter into the power connector on the top, left side of the printer. Figure 3 2. Plug the other end of the power adapter into a power outlet. Inserting the Tape Cassette Your printer comes with one label tape cassette. Visit www.dymo.com for information about purchasing additional label cassettes. To insert the tape cassette 1. Press the thumb catch on the right side of the printer to open the tape cassette door. 2. Set the cassette switch for the size of the tape cassette that you are inserting. See Figure 4. A notch in the cassette fits over the switch when the cassette is in the correct position. The first time you use the printer, remove the protective cardboard insert from between the print head and pinch roller. See Figure 4. Remove cardboard insert Tighten tape = 6 mm = 9/12 mm = 19 mm Set cassette switch Figure 4 3. Make sure the tape and ribbon are taut across the mouth of the cassette and that the tape passes between the guideposts. If necessary, turn the spool clockwise to tighten the ribbon. 4. Insert the cassette with the tape and ribbon positioned between the print head and pinch roller. See Figure 5. Push down gently Print Head Pinch Roller Figure 5 5. Press firmly until cassette clicks into place. Make sure tape and ribbon are positioned correctly. A 6. Close the tape cassette door and press to turn on the power. 44 Manual_RhinoPRO5000_WEU.indd 4 23-07-2004 10:51:16