Dynex DX-19L150A11 User Manual (English) - Page 21

18 DX-15L150A11/DX19L150A11/DX-22L150A11 Changing channel settings Changing channel settings Automatically scanning for channels When you scan for channels, your TV searches for channels with signals and stores the channel information in the channel list. When you press CH or CH , your TV goes to the next or previous channel in the channel list and skips the channels that do not have signals. If the TV signal source changes, for example if you change from an outdoor antenna to cable TV (no box), you need to scan for channels. To auto scan for channels: 1 Press MENU. The on-screen menu opens. If you don't need analog channels after auto searching for digital channels, you can press EXIT or MENU within ten seconds of the prompt. You don't need to scan for channels if you are using a cable or satellite box because the available channels are provided by the box. Press EXIT to close the menu. 5 Press MENU to return to the previous menu, or press EXIT to close the menu. Hiding and adding channels You can delete channels from the channel list so that your TV skips the channels when you press CH /CH . You can still tune to the hidden channel by using the number buttons. You can also add channels to the list. To hide or add a channel: 1 Press MENU. The on-screen menu opens. 2 Press or to highlight CHANNELS. The CHANNELS menu opens. 2 Press or to highlight CHANNELS. The CHANNELS menu opens. 3 Press or to highlight Auto Channel Search, then press ENTER. The Auto Channel Search screen opens. 3 Press or to highlight Add/Skip Channels, then press ENTER or . The Channel List screen opens. 4 Press or to select Antenna or Cable, then press ENTER to start the scan. You can see the progress of the search and the number of channels found in the on-screen menu. After the scan is complete, the menu closes and your TV tunes to the first channel on the list. Notes: You can press EXIT to stop the search at any time. 4 Press , , or to highlight the channel you want to hide or add (the default is to show the channel), then press ENTER to remove the check mark from the channel. You can also add a channel by selecting it, then pressing ENTER to place a check mark next to it.