Dynex DX-UPDVD2 User Manual (English) - Page 13

Specifications DX-UPDVD2 11 Cleaning discs Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the center out. General Power Power consumption Dimensions (LxWxH) Weight Operating temperature Operating humidity 110~120 V 50/60 Hz 12 W 14.173 x 8.267 x 1.3 inches (359.99 x 209.98 x 33.02 mm) 4.08 lbs. (1.86 kg) 41°F to 95°F (5°C to 35°C) 5% to 90% Do not use strong solvents such as alcohol, benzine, thinner, commercially available cleaners, or anti-static spray intended for older vinyl records. Note: Never operate this player immediately after moving it from a cold location to a warm location. Leave it for two or three hours without operating it. If you use this product in such a situation, it may damage discs or internal parts. Resetting your player Reset your player if you observe any of the following symptoms: • Your player is plugged in, but the power will not turn on or off. • The display window is not working. • Your player does not operate normally. To reset your player: • Unplug the power cord for 30 minutes, then plug in the power cord again. Specifications System and outputs VF Signal system NTSC Frequency response CD: 20 Hz~20 KHz (EIAJ) DVD: 20 Hz~44 KHz (96 KHz)(Sample result) 20 Hz~22 KHz (48 KHz)(Sample result) Audio S/N ratio > 90 dB Audio MPEG LAYER2 standard Audio output (analog Electric level output: 1.8 ± 0.2 V audio) Resistance: 10 Kohm Audio output (digital Electric level output: 0.5 V p-p audio) Resistance: 75 ohm Composite video output Electric level output: (1.0 ± 0.2) V p-p Resistance: 75 ohm Unbalanced negative Component video (Y, Electric level output: 0.7 V p-p Cb, Cr) Resistance: 75 ohm Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. Notices Specifications and features are subject to change without notice or obligation. For service and support call (800) 305-2204.