EdgeStar AP13500G Owners Manual - Page 18

Operating Instructions: Control Panel Overview Dry Fan Heat On/Off Mode Select Buttons Fan Speed Timer Mode Sleep Mode Press the button once to manually turn the unit on. Press once more to turn the unit off. Press the MODE button to cycle between modes: COOL Æ DRY Æ FAN Æ HEAT. COOL: Cool indicator is bright. Display will show set temperature (61ƕ F - 86ƕ F). DRY: Dehumidify indicator is bright. Display will be blank. FAN: Fan indicator is bright. Display will be blank. Remember that the exhaust hose and window kit must be installed when the unit is in Cool or Dry Mode. HEAT: Heat indicator is bright. Display will show set temperature (61ƕ F - 86ƕ F). In COOL or HEAT mode, press the or buttons to decrease or increase the temperature by 1° degree Fahrenheit. Continue to press to get to desired temperature. Cool Mode range 61° F - 86° F. Heat Mode Range 61° F - 86° F When the unit is running in Cool or Fan mode, press the arrow buttons to select the fan speed desired. There are 4 fan settings, LOW Æ MED Æ TURBO Æ AUTO. Press the Timer button to enter timer mode. Press the or buttons the adjust the timer setting in increments of ½ hour up to 10 hours and then in increments of 1 hour up to 24 hours while using the remote control. The display will remain in timer mode for 5 seconds and then revert back to displaying temperature. Press the Timer button again to cancel the timer mode. Press the Sleep Button to enter sleep mode. The Sleep Mode can be activated when in Cool Mode or Heat Mode and will not operate when in Fan Mode. When operating in Cool Mode, the Sleep function will slowly raise the Temp Control by 4° degrees Fahrenheit over the initial 2 hour Sleep Mode period. When operating in Heat Mode, the Sleep function will slowly lower the Temp Control by 4° degrees Fahrenheit over the initial 2 hour Sleep Mode period. When the Sleep Mode is active, the LCD will continue to display the Sleep Mode status. Edgestar Portable Air Conditioner 14