Edimax ES-5808PHG Manual - Page 29

RSTP Status

Page 29 highlights

¾ Port: The port number. ¾ Port Active: Shows if the port is a member of an active LACP group. ¾ Partner Port Number: A list of the ports attached at the remote end of this LAG link member. ¾ Operational Port Key: Current operational value of the key used by this LAG. LACP Port Status RSTP Status RSTP VLAN Bridge Overview Figure 2-3-2 Figure 2-4-1 ¾ Hello Time: Interval (in seconds) at which the root device transmits a configuration message. ¾ Max Age: The maximum time (in seconds) a device can wait without receiving a configuration message before attempting to reconfigure. All device ports (except for designated ports) should receive configuration messages at regular intervals. Any port that age out STA information (provided in the last configuration message) becomes the designated port for the attached LAN. If it is a root port, a new root port is selected from among the device ports attached to the network. 28

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37

28
¾
Port: The port number.
¾
Port Active: Shows if the port is a member of an active LACP group.
¾
Partner Port Number: A list of the ports attached at the remote end of this
LAG link member.
¾
Operational Port Key: Current operational value of the key used by this
LAG.
LACP Port Status
Figure 2-3-2
RSTP Status
RSTP VLAN Bridge Overview
Figure 2-4-1
¾
Hello Time: Interval (in seconds) at which the root device transmits a
configuration message.
¾
Max Age: The maximum time (in seconds) a device can wait without
receiving a configuration message before attempting to reconfigure. All
device ports (except for designated ports) should receive configuration
messages at regular intervals. Any port that age out STA information
(provided in the last configuration message) becomes the designated port
for the attached LAN. If it is a root port, a new root port is selected from
among the device ports attached to the network.