Electrolux EFDE210TIW Installation Instructions English Spanish French - Page 7

Installation Instructions 7 Electrical connection (non-Canada) - 3 wire cord 3-wire receptacle (NEMA type 10-30R) 30 AMP NEMA 10-30 Neutral (center wire) WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. 1 Turn off power supply to outlet. 2 Remove the three screws securing the terminal block access cover in the upper corner on the back of the dryer. 3 Using an UNPLUGGED, UL-approved, 30 amp. power cord, NEMA 10-30 type SRDT, attach the neutral (center wire) conductor to the SILVER colored center terminal on the terminal block. Tighten the screw securely. NOTE Terminal screws were shipped from the factory temporarily attached inside the access cover. 4 Attach the remaining two power cord outer conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely. WARNING ELECTRICAL SHOCK HAZARD Do not make a sharp bend or crimp wiring/conductor at connections. 5 Reinstall the terminal block cover. WARNING ELECTRICAL SHOCK HAZARD Do not operate dryer without terminal cover in place. A correctly installed terminal block cover also acts a qualified strain relief for the power cord. terminal cover access cover screw DO NOT REMOVE THIS SCREW access cover screw access cover screw line 1 - L1 (BRASS terminal) neutral - N (SILVER terminal) line 2 - L2 (BRASS terminal) internal ground (GREEN screw) route cord here neutral terminal IMPORTANT If moving dryer from a 4-wire system and installing it now in a 3-wire system, move the internal ground wire from the center terminal back to the GREEN screw under the terminal block. DO NOT move internal ground in a 3-wire system!