Electrolux EFDE210TIW Installation Instructions English Spanish French - Page 8

8 Installation Instructions Electrical connection (non-Canada) - 4 wire cord 4-wire receptacle (NEMA type 14-30R) 30 AMP NEMA 14-30 Neutral Ground (WHITE wire) (GREEN wire) WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. 1 Turn off power supply to outlet. 2 Remove the three screws securing the terminal block access cover in the upper corner on the back of the dryer. 3 Disconnect the internal (WHITE) dryer harness ground wire from the (GREEN) ground screw next to the terminal block. 4 Using an UNPLUGGED, UL-approved, 30 amp. power cord, NEMA 14-30 type ST or SRDT, attach the ground (GREEN) power cord wire to the cabinet with the ground (GREEN) screw. Tighten the screw securely. NOTE Terminal screws were shipped from the factory temporarily attached inside the access cover. 5 Move the internal dryer harness ground (WHITE) wire to the terminal block and attach it along with the neutral (WHITE) power cord wire conductor to the center, SILVER colored terminal on the terminal block. Tighten the screw securely. 6 Attach the RED and BLACK power cord conductors to the outer, BRASS colored terminals on the terminal block. Tighten both screws securely. WARNING ELECTRICAL SHOCK HAZARD Do not make a sharp bend or crimp wiring/conductor at connections. 7 Reinstall the terminal block cover. WARNING ELECTRICAL SHOCK HAZARD Do not operate dryer without terminal cover in place. A correctly installed terminal block cover also acts a qualified strain relief for the power cord. BLACK or RED power wire WHITE neutral wire GREEN ground wire terminal cover access cover screw DO NOT REMOVE THIS SCREW access cover screw access cover screw line 1 - L1 (BRASS terminal) neutral - N (SILVER terminal) line 2 - L2 (BRASS terminal) move internal ground wire to the center terminal for 4-wire system route cord here neutral terminal GREEN ground screw BLACK or RED power wire