Electrolux EFME617STT Installation Instructions English Spanish French - Page 15

Water connection Steam Model only - dryer model

Get Electrolux EFME617STT PDF manuals and user guides View all Electrolux EFME617STT manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

Installation Instructions Water connection (Steam Model only) WATER SUPPLY REQUIREMENTS Cold water faucet MUST be installed within 42 inches (107 cm) of your dryer's water inlet. The faucet MUST be 3/4 inch (1.9 cm) with threading for laundry hose connection. Water pressure MUST be between 30 and 120 psi. Your water department can advise you of your water pressure. 1. Turn off COLD water supply to washer, 2. Remove COLD inlet hose from COLD water supply and inspect for rubber washer. Replace washer if it is torn or worn out. 15 RUBBER WASHER MUST BE PRESENT AND UNDAMAGED COLD INLET HOSE TO WASHER 3. Momentarily turn on COLD supply and run some water into a bucket or container to clear any contaminants in the line. 4. Remove hose kit from dryer drum and inspect hose couplings for proper placement of rubber washers. RUBBER WASHERS MUST BE PRESENT

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
15
Installation Instructions
Water connection (Steam Model only)
1.
Turn off
COLD water supply to washer,
2.
Remove COLD inlet hose from COLD water
supply and inspect for rubber washer.
Replace washer if it is torn or worn out.
3.
Momentarily turn on COLD supply and run
some water into a bucket or container to
clear any contaminants in the line.
4.
Remove hose kit from dryer drum and
inspect hose couplings for proper
placement of rubber washers.
RUBBER WASHER
MUST BE PRESENT
AND UNDAMAGED
COLD INLET HOSE
TO WASHER
WATER SUPPLY REQUIREMENTS
Cold water faucet MUST be installed within 42
inches (107 cm) of your dryer’s water inlet. The
faucet MUST be 3/4 inch (1.9 cm) with thread-
ing for laundry hose connection. Water pressure
MUST be between 30 and 120 psi. Your water de-
partment can advise you of your water pressure.
RUBBER WASHERS
MUST BE PRESENT