Electrolux EFME617STT Installation Instructions English Spanish French - Page 17
Important, Caution - review
View all Electrolux EFME617STT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Installation Instructions General installation 1. Connect the exhaust duct to the outside exhaust system. Use of a 4" (102 mm) clamp (item A) is recommended to connect the dryer to the exhaust vent system. Use metal foil tape to seal all other joints. 2. Use a carpenter's level to level your dryer front-to-back and side-to-side. 3. Use adjustable pliers to adjust the leveling legs so the dryer is level front-to-rear and side-to-side, and stable corner-to-corner. 4. Press down on alternate corners and sides and feel for the slightest movement. Adjust the appropriate leg(s) so the dryer sits solidly on the floor on ALL four legs. Keep the leveling leg extension at a minimum for best performance of the dryer. A IMPORTANT Be sure the power is off at a circuit breaker/ fuse box before plugging the power cord into an outlet. 5. Plug the power cord into a grounded outlet. Grounding type wall receptacle Do not, under any circumstances, cut, remove, or bypass the grounding prong. 17 Power cord with 3-prong grounded plug 6. Turn on the power at the circuit breaker/fuse box. 7. Read the Use & Care Guide provided with the dryer. It contains valuable and helpful information that will save you time and money. 8. If you have any questions during initial operation, please review the "Avoid Service Checklist" in your Use & Care Guide before calling for service. 9. Place these instructions in a location near the dryer for future reference. NOTE A wiring diagram and technical data sheet are located under the dryer top panel. CAUTION When discarding or storing your old dryer, remove the door.