Electrolux EI24BC15VS Complete Owners Guide English - Page 9

Installation 9 Installing the Anti-Tip Bracket CAUTION If your Wine Cooler/Beverage Center is not located under a counter top (free standing), you must use an anti-tip bracket installed as per these instructions. If the Wine Cooler/ Beverage Center is removed from its location for any reason, make sure that the bracket is properly engaged when you push the Wine Cooler/Beverage Center back into the original location. If the bracket is not properly engaged, there is a risk of the Wine Cooler/ Beverage Center tipping over, causing property or personal injury if you or a child stand, sit, or lean on an open shelf. CAUTION Any finished flooring should be protected with appropriate material to avoid damage when moving the unit. ALL UNITS CAN TIP NOTE While performing installation described in this section, gloves, safety glasses, or goggles should be worn. WARNING This appliance may tip when shelves are extended, causing damage or injury. If this appliance is used in a FREE STANDING application, the anti-tip bracket must be installed following these instructions! IMPORTANT Determine the final location of the appliance before attempting to install the bracket. You will need to choose one of the three installation methods below. Installation methods: 1. DRYWALL 2. WOOD FLOOR 3. CONCRETE FLOOR Anti-tip bracket installation The bracket can be installed at the left bottom OR right bottom of the back of the unit. You can choose which side is convenient for you. Tools you will need: Safety goggles Stud finder Screwdriver Gloves Hammer or Mallet Electric drill with 3/8" drill bit Wrench