Electrolux EI48HI55KS Complete Owner's Guide (Français) - Page 10
Remote Blower Motor, Installation into Hood Insert
View all Electrolux EI48HI55KS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 Blower Motor Systems Installation Remote Blower Motor Installation into Hood Insert A. Front cover B. Blower mounting bolts (4) A C. Spring clip D. Motor electrical plug Prepare for Mounting the Remote Blower System The remote blower system must be fastened to a secure structure of the roof, ceiling, wall, floor, or new or existing frame construction. The 4 holes on either the inlet (bottom) side or the outlet (top) side of the blower must be used to mount the remote blower system to the structure. NOTE: The mounting hole locations must span the studs. Additional stud framing may be required. Plywood may be used to span open areas between ceiling joists or roof rafters to aid installation. This structure must be strong enough to support the weight of the remote blower system (50 lb [22.6 kg] min). Prepare the Remote Blower System BC D Install Remote Blower Motor System NOTE: The blower motor housing can be mounted using 4 holes from either the inlet side or the outlet side of the blower. Excessive Weight Hazard Use two or more people to move and install Remote blower motor system. Failure to do so can result in back or other injury. A A Inlet Side 1. Using two or more people, move the remote blower motor system to the mounting location. 2. Remove the 10 screws from the front cover of the remote blower motor housing and set them aside. 3. Remove the front cover of the remote blower motor housing and set it aside. NOTE: To make the blower motor housing easier to mount, the blower motor assembly can be removed. If you do not want to remove the blower motor assembly, proceed to "Install Remote Blower System" in this section. To Remove Blower Motor 1. Disconnect the motor electrical plug from the blower motor assembly. 2. Remove the screws that secure the blower motor assembly to the remote blower housing and set them aside. 3. Pull the spring clip to release the blower motor assembly. Remove the blower motor assembly from the housing and place it on a covered surface. A. Mounting holes A A A A Outlet Side 1. Position the remote blower motor housing in its mounting location and mark the 4 mounting hole locations. 2. Drill 4 mounting pilot holes using a ³⁄16" (5 mm) drill bit. 3. Attach the remote blower motor housing to the mounting location with four 6 x 80 mm mounting screws and washers. 4. If Blower Motor is removed, reinstall the blower motor assembly and secure it with the screws