Electrolux EI48HI55KS Complete Owner's Guide (Français) - Page 14

14 Make Electrical Connections Make Electrical Power Supply Connection to Hood Insert Electrical Shock Hazard Disconnect power before servicing. Replace all parts and panels before operating. Failure to do so can result in death or electrical shock. 1. Disconnect power. 2. Locate terminal box inside of the hood insert. G E A B C D F 5. Connect green (or bare) ground wire from home power supply to the green/yellow ground wire (D) in terminal box using UL listed wire connectors. 6. Install terminal box cover. 7. Check that all light bulbs are secure in their sockets. 8. Reconnect power. Complete Installation and Check Operation 1. Install grease filters. See the "Cleaning" section. See page 15. 2. Check operation of the Hood Insert blower and lights. See the "Hood Insert Use" section. See page 15. A BC A A.White wires B. Black wires C. UL listed wire connectors D. Green, bare or yellow/green wires E.Home power supply F. UL listed or CSA approved ¹⁄2" (1.3 cm) strain relief G. Ground Wire tab 3. Use UL listed wire connectors and connect black wires (B) together. 4. Use UL listed wire connectors and connect white wires (A) together. Electrical Shock Hazard Electrically ground blower. Connect ground wire to green and yellow ground wire in terminal box. Failure to do so can result in death or electrical shock. D A E F A A. Halogen lights B. Halogen light switch C. Blower control switche D. Grease filter handle E. Grease filter F. Filter Spacer (Only for EI30HI55KS model) 3. If the hood insert does not operate, check to see whether a circuit breaker has tripped or a hous hold fuse has blown. 4. Disconnect power supply and check that the wiring is correct. NOTE: To get the most efficient use from your new hood insert, read the "Hood Insert Use" section. NOTE: When using an Remote blower motor system, the green (or green/yellow) ground wire in the conduit from the Remote blower motor system is to be connected with the green (or bare) wire of the home power supply cable and with the green/yellow wire (D) in the terminal box.