Electrolux EWFLW65H Installation Instructions - Page 10
installation, instructions
 |
View all Electrolux EWFLW65H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
installation instructions Connecting inlet water 1. Run some water from the hot and cold faucets to flush the water lines and remove particles that might clog the water valve screens and to determine which faucet is hot and which is cold supply. 2. Look in the end of each water supply inlet hose and verify that the rubber washers are in place. RUBBER WASHERS MUST BE PRESENT 3. Connect the HOT inlet hose to the HOT water supply and the COLD inlet hose to the COLD water supply. Tighten by hand until snug. 4. Tighten each supply connection another 2/3 turn with pliers. 5. Turn on the water and check for leaks.
-
1 -
2
-
3
-
4
-
5 -
6 -
7 -
8 -
9 -
10 -
11 -
12 -
13 -
14 -
15 -
16
-
17
-
18
-
19
-
20
 |
 |
installation
instructions
Connecting
inlet
water
1.
Run some water from the hot and cold faucets
to flush the water lines and remove particles
that might clog the water valve screens and to
determine
which faucet is hot and which is cold
supply.
2.
Look in the end of each water supply
inlet hose
and verify that the rubber washers
are in place.
RUBBER WASHERS
MUST BE PRESENT
3. Connect
the HOT inlet hose to the HOT water
supply
and the COLD inlet hose to the COLD
water supply. Tighten
by hand until snug.
4. Tighten each supply connection
another 2/3
turn with pliers.
5. Turn on the water and check for leaks.