Electrolux EWFLW65H Installation Instructions - Page 13

Reversing Door Preparing to reverse door swing 1 Be sure you have adequate swing area before reversing door. 2 You will need a screw driver with a #2 square bit. 3 Protect flat work surface, such as top of washer or floor near washer, with a soft cloth or towel. 4 Be sure washer is unplugged from power source! Tools needed: % Screwdrivers with #2 square & straight bit Removing door and hardware A) Removing Trim Ring 1 Open the door to a 90 degree angle. 2 Remove and save the trim plug and long, course-thread, panhead screw. B) Removing Door from Hinge 1 Reopen door to 90 degree angle. 2 Remove 4 long, course-thread, counter-sunk hinge screws from door. 3 Close the door. 4 Rotate the door trim approximately 3/4" counter-clockwise and pull it away from the front of the door. 3 While supporting the weight of the door with both hands, separate the door from the hinge. / / ! / t 4 Gently place the door face down on a flat, covered work surface.