Epson 4880 Product Information Guide - Page 4

Epson Stylus Pro 4880 Error Messages When a problem occurs, a message appears on the display and the lights on the control panel come on or flash. Message/Light CHANGE PAPER TYPE COMMAND ERROR Light Paper light on - DRIVER INK SET SETTING IS - WRONG MISMATCH ERROR Note: These messages alternate. Explanation Response Paper loaded does not match the source selected. Press the Paper Source button to select the correct setting: either (for paper in the tray, or or for roll paper). You're using the wrong printer driver. Press the pause button and hold it for 3 seconds to cancel the print job. Make sure you installed the correct driver for your printer. Damaged data was sent to the printer Press the pause button and hold it for 3 seconds to or the data has an incorrect command. cancel the print job. The installed printer driver is not correct for the printer. Stop printing, and press the pause button for 3 seconds. Then make sure that the installed printer driver is correct for the printer. The black ink cartridge option does not match what is selected in the driver. Stop printing, and then press and hold the pause button for 3 seconds. Select the correct black ink cartridge option in the driver. If you want to continue printing, press the pause button. Non-Epson genuine ink cartridge is installed. Press the pause button for 3 seconds to cancel printing. If you want to continue printing, press the pause button again. FEED SHEET PAPER - FEED SHEET PAPER MANUALLY FORBIDDEN MEDIA FROM P. - TRAY INK LOW B Ink light flashing INVALID INK CRTG B Ink light on Cut sheet needs to be loaded manually. Cut sheet needs to be loaded manually in the front or rear manual feed slot. Ink cartridge(s) are nearly expended (printing continues). You tried to install the wrong ink cartridge. Load the sheet in the front or rear manual feed slot. Remove the cut sheet media from the paper tray and load it in the correct slot. Make sure you have replacement cartridges available; you'll need to replace them soon. If you are installing ink cartridges for the first time, you must install the cartridges that came with your printer. LOAD PAPER LOAD ROLL PAPER LOAD SHEET PAPER IN P. TRAY LOWER INK LEVERS LOWER L (or R) INK LVR MNT REQ. nnnn MNT TK NEAR FULL MNT TNK FULL Paper light on Paper light on - If you are replacing ink cartridges, check the package and product code. Replace the cartridges with genuine Epson ink cartridges. Paper lever is in the released position After you finish loading paper, pull the paper lever all while loading paper. the way forward, to the secured position. Paper source setting in printer driver is different from control panel. Make sure the right paper is loaded and the paper source setting is the same on the control panel and printer driver. One or both ink levers are raised. Pull the lever or levers down to lock the ink cartridges. - - B Ink light on A printer part (nnnn) will need to be replaced soon. The maintenance tank is almost full. The maintenance tank is full. Note the code number and contact Epson. Although you can continue printing, you need to replace the maintenance tank with a new one as soon as possible. Make sure you have a replacement maintenance tank on hand. Replace the maintenance tank with a new one. 4 12/07