Epson 8300NL Product Information Guide - Page 19
Replacing the Lamp, Warning - parts
UPC - 010343846029
View all Epson 8300NL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
EPSON PowerLite 8300i Projector Replacing the Lamp The projection lamp typically lasts for about 3000 hours in low-brightness mode, or 2000 hours in high-brightness mode. Note: The brightness setting can be changed by selecting Brightness Control in the projector's Advanced2 menu. It is time to replace the lamp when: ❏ The projected image gets darker or starts to deteriorate. ❏ The message LAMP REPLACE appears on the screen when the lamp comes on and the lamp warning light is flashing orange. To maintain projector brightness and image quality, replace the lamp as soon as possible. ❏ The lamp warning light burnt out). is flashing red (the lamp is Contact your dealer or call EPSON at (800) 873-7766 in the United States for a replacement lamp. Request part number V13H010L23. In Canada, please call (800) 463-7766 for dealer referral Follow these steps to replace the lamp: 1. Turn off the projector. 2. When the power light stops flashing, unplug the power cord and let the projector cool. Warning: Let the projector cool for at least half an hour, if it has been on. The lamp is extremely hot immediately after use. 3. If the projector is mounted on the ceiling, remove the rear cover. 4. Loosen the lamp cover screws (you don't need to take them out all the way). Then remove the cover. 5. Loosen the three screws holding the lamp in place (you can't remove them). 6. Grasp the wire handle as shown and pull the lamp straight out. 1 Release tab to remove rear cover 2 7. Gently insert the new lamp. 8. Once the lamp is fully inserted, tighten its screws and replace the cover. (The projector won't come on if the lamp cover is loose.) 9. Reset the lamp timer (select Reset Lamp Timer in the projector's About menu). 18 - EPSON PowerLite 8300i Projector 5/03