Epson ActionLaser 1500 User Setup Information - Page 8

Attaching the power cord, Test printing

Get Epson ActionLaser 1500 PDF manuals and user guides View all Epson ActionLaser 1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

4 Attaching the power cord 1. Make sure the power switch at the top right of the printer is turned off. 2. Insert the power cord into the back of the printer. Then plug the other end into a properly grounded outlet. 5 Test printing 1. Make sure the imaging cartridge is installed. Turn on the printer. Several messages appear as the printer performs internal tests. After about 35 seconds, the READY message appears. 2. Press the LEVEL 2 button to enter SelecType Level 2. 3. Press 'I until FEATURE PRINT appears on the display. 4. Press ) twice holding down the button until the display begins to flash to print the feature print. 5. After the feature print is complete, press the EXIT button to exit SelecType.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
4
Attaching the power cord
1.
Make sure the power switch at the top right of the printer is
turned off.
2.
Insert the power cord into the back of the printer. Then plug
the other end into a properly grounded outlet.
5
Test printing
1.
2.
3.
4.
5.
Make sure the imaging cartridge is installed. Turn on the
printer. Several messages appear as the printer performs
internal tests. After about 35 seconds, the
READY
message
appears.
Press the
LEVEL 2
button to enter SelecType Level 2.
Press
‘I
until
FEATURE PRINT
appears on the display.
Press
)
twice holding down the button until the display
begins to flash to print the feature print.
After the feature print is complete, press the EXIT button to
exit SelecType.