Epson ActionLaser 1500 User Setup Information - Page 9

Connecting the printer to the computer - parts

Get Epson ActionLaser 1500 PDF manuals and user guides View all Epson ActionLaser 1500 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

6 Connecting the printer to the computer You can connect up to three computers (two for the ActionLaser 1000) to your printer at the same time. If you are connecting more than one computer, see "Sharing Your Printer" in the Reference Guide. To connect a parallel (factory setting), serial (built-in on the ActionLaser 1500 only), or optional interface, follow these steps. For information on optional interface boards, see Chapter 5 in the Reference Guide. 1. Make sure both the printer and the computer are off. 2. Connect a properly shielded interface cable to the appropriate interface connector. Parallel cables should be the twisted-pair type. 3. Plug the other end of the cable into your computer. 4. Insert the interface cable into the u-shaped part of one cable clip. Lift the left side of the printer up slightly. Then hook the short lip of the clip into the forward slot and push the bottom of the clip under the printer until it clicks in place. Repeat this procedure with the second clip and insert it into the back slot. 6 Setup

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
6
Connecting the printer to the
computer
You can connect up to three computers (two for the
ActionLaser 1000) to your printer at the same time. If you are
connecting more than one computer, see “Sharing Your
Printer” in the Reference Guide. To connect a parallel (factory
setting), serial (built-in on the ActionLaser 1500 only), or
optional interface, follow these steps. For information on
optional interface boards, see Chapter 5 in the
Reference Guide.
1.
Make sure both the printer and the computer are off.
2.
Connect a properly shielded interface cable to the
appropriate interface connector. Parallel cables should be
the twisted-pair type.
3.
Plug the other end of the cable into your computer.
4.
Insert the interface cable into the u-shaped part of one cable
clip. Lift the left side of the printer up slightly. Then hook
the short lip of the clip into the forward slot and push the
bottom of the clip under the printer until it clicks in place.
Repeat this procedure with the second clip and insert it into
the back slot.
6 Setup