Epson C80N Start Here Card - Page 3

Connect the Printer, USB Cable Users (Windows or Mac), Parallel Cable Users (Windows only

Page 3 highlights

5 Close the cartridge cover. 6 Press the ink button and close the printer cover. The green power light flashes as your printer charges ink for several seconds. CAUTION: Don't turn off the printer while the green power light is flashing, unless the printer hasn't moved or made any noise for more than 5 minutes. 4 Connect the Printer Printer cables are not included with your printer. You need only one of the following cables: • USB cable (Windows® or Macintosh®) or • Parallel cable (Windows only). NOTE: If you have Windows NT 4.x, you must use a parallel cable. USB Cable Users (Windows or Mac®) 1 Make sure your computer is turned off. Keep it turned off until section 6, "Install Software." 2 Plug the square end of the cable into the USB port on the back of the printer. 3 Plug the flat end of the cable into your computer's USB port until it stops. (You can use any open USB port.) Flat end Square end Parallel Cable Users (Windows only) 1 Make sure your computer is turned off. Keep it turned off until section 6, "Install Software." 2 Plug the end of the cable with the slotted connector into the parallel port on the side of the printer, then secure it with the wire clips. 3 Plug the end of the cable with the screws on the side into your computer's parallel port and secure it. End with screws Slotted end Turn over

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6

Connect the Printer
Connect the Printer
Printer cables are not included with your printer. You need
only one
of the
following cables:
• USB cable (Windows
®
or Macintosh
®
)
or
• Parallel cable (Windows only).
NOTE
: If you have Windows NT 4.x, you must use a parallel cable.
USB Cable Users (Windows or Mac
®
)
1
Make sure your computer is turned off. Keep it turned off until section 6,
“Install Software.”
2
Plug the
square end of the cable into the USB port on the back
of the printer.
3
Plug the
flat end of the cable into your computer’s USB port until it stops.
(You can use any open USB port.)
Parallel Cable Users (Windows only)
1
Make sure your computer is turned off. Keep it turned off until section 6, “Install
Software.”
2
Plug the end of the cable with the slotted connector into the parallel port on the side
of the printer, then secure it with the wire clips.
3
Plug the end of the cable with the screws on the side into your computer’s
parallel port and secure it.
4
4
5
Close the cartridge cover.
6
Press the ink button and close the
printer cover.
The green power light flashes as your
printer charges ink for several seconds.
CAUTION
: Don’t turn off the printer
while the green power light is
flashing, unless the printer hasn’t
moved or made any noise for more
than 5 minutes.
Flat end
Square end
Slotted
end
End with screws
Turn over